Tool to adjust tension belts Thema 8.32 (1860756000)

Vraagbaak techniek
Plaats reactie
Jepson75
Berichten: 44
Lid geworden op: 08 jun 2019, 10:02
Locatie: Vänersborg Sweden

Tool to adjust tension belts Thema 8.32 (1860756000)

Bericht door Jepson75 » 27 jun 2019, 22:20

How do you adjust the timing belts if You don´t have tool 1860756000?
Is there a way to do it without it?

Realized that I have to replace the timing belts...They´ve been replaced, but that was five years ago and the belts were bought 2009 :-(
I will try to do it, without removing the Engine...as it´s said to be possible (and the first owner in Sweden told me they had modified the car in some way to make it possible!

Gebruikersavatar
Maarten-Jan
Site Admin
Berichten: 4300
Lid geworden op: 19 okt 2008, 00:01
Locatie: Zwolle
Contacteer:

Re: Tool to adjust tension belts Thema 8.32 (1860756000)

Bericht door Maarten-Jan » 28 jun 2019, 09:47

It's possible to do the change of belts with the engine in the car. You will need an Allen key which you shorten a bit to gain access to the bolts of the cover of the rear belt. Removing the covers is the difficult job. Perhaps they have drilled a hole to give acces to the most difficult bolt. You will see. I always put tension on thr belts by using feeling and experience. I always check tension after some turns of the engine. Good luck!
Echt snelle auto's vallen stilstaand niet op!

Lancia Thema 8.32 SW

Jepson75
Berichten: 44
Lid geworden op: 08 jun 2019, 10:02
Locatie: Vänersborg Sweden

Re: Tool to adjust tension belts Thema 8.32 (1860756000)

Bericht door Jepson75 » 28 jun 2019, 23:27

Maarten-Jan schreef:
28 jun 2019, 09:47
It's possible to do the change of belts with the engine in the car. You will need an Allen key which you shorten a bit to gain access to the bolts of the cover of the rear belt. Removing the covers is the difficult job. Perhaps they have drilled a hole to give acces to the most difficult bolt. You will see. I always put tension on thr belts by using feeling and experience. I always check tension after some turns of the engine. Good luck!
Thank you for your advise. :)
I'll always used 1/4 of a turn on the belt as a measurement on an ok tension for belts. But I might ask someone with more experience this time. :)

Plaats reactie

Terug naar “Techniek”